Parts for the Popp-O-Mat prototype complete
All parts for the prototype are here now.
The microcontroller board was programmed in the software laboratory with the initial firmware version 1.0. The assembly will be started immediately.
These are the main steps for assembling the Popp-O-Mat prototype:
-
Drill the holes into the enclosure for the ON/OFF switch, indicator LED’s and connectors for the human body electrodes
-
Wire up the battery connector with the ON/OFF switch and ground of the microcontroller
-
Wire up the LED’s, connectors and microcontroller board
-
Install the electronics into the enclosure
-
Assemble the enclosure together
This process takes about one hour for our professional team in the prototyping department.
Comments Off on Parts for the Popp-O-Mat prototype complete